Japanese-ish looking doors, for a northern climate with lots of wind. Central (stressed component) sheet […]
Author: mjr
mjr
Skew Chisel and Roughing Gouge
I finished bolting down the lathe and was looking at my selection of chisels, and […]
W2 Bog Oak and Silver yanagiba
Title pretty much says it all. Wrapped some silver around a mandrel, soldered it with […]
Letter Opener
Blade is 1095/15N20 twist, parkerized. Handle is ebony with boxwood burl. Scabbard is oak.
Voyager’s Trimmer
Face-on wire rope damascus, ebony bolster and fiddleback maple. The maple is from an old […]
Aaron’s Slicer
Chisel-ground blade of 1095 high carbon steel wire rope, welded and crushed end-on. Differential tempered […]
Anna’s Knife
I made this for my girlfriend, Anna. It’s 200+ layers of wrought iron and 1095 […]
Jazzlet’s Eye-Gouger 2.0
End-forged 1095 wire rope damascus. Thick wedge-shaped blade with strong tang. Handle is burl maple […]
Chef’s Saber
Blade length is about 12″, handle is about 6″ – this thing is big, thin, […]
Olaf’s Slicer
This was an experiment in pulling a hamon out of W-2. But why throw it […]